Blade mCX2 RTF Manual de Instruções descarregar pdf (Página 12)

IfyoudecidetouseanE-iteLP5DSMtransmitter,pleasepositionyourchannelreversaldipswitches

as follows:

If you’ve conﬁrmed proper control operation of your Blade mCX2, unplug the ﬂight battery.

Channel 5 Information

Channel 5 affects rate settings of the 5-in-1 Control Unit.

• IfusingthestockMLP4DSMTransmitter,pleasereadPage21ofthismanualforDualRate

information.

• IfusinganLP5DSMTransmitter,pleaseturntheChannel5knobclockwise

completely.

• IfusinganyotherDSMXcompatibletransmitter,pleaseensureChannel5issettodefaultservo

reversalandtheswitchorknobissettoapositionthatallowsfulltravelcontrol.

Note:Thiscaneasilybetestedbyinducingfullcyclic(Aileron/Elevator)inputandmovingtheswitchor

knob.There’sapproximately10–15%lessservotraveldependingonwhatpositionChannel5isin.

5-in-1 Control Unit Description, Arming and Motor Control Test

The unique Control Unit installed on your Blade mCX2 is a lightweight combination of main motor

electronicspeedcontrols,mixer,gyro,servosandSpektrumDSMXcompatiblereceiver.The5-in-1unit

is also equipped with a status indicator LED.

Thefollowingchecklistcontainsthestepstoensureproperarmingandoperationofthecontrolunit,as

well as proper motor response:

❏ BeforeeachightALWAYSturnthetransmitteronbeforeconnectingtheightbatterytothe

5-in-1 unit. Never connect the ﬂight battery to the 5-in-1 unit before powering the transmitter on

ﬁrst. After each ﬂight, always disconnect the ﬂight battery from the 5-in-1 unit before powering

the transmitter off.

Note: the only time you should connect the ﬂight battery to the 5-in-1 unit before powering the

transmitter on is when you are binding the receiver of the 5-in-1 unit to the transmitter. Please see the

Transmitter and Receiver Binding section of this manual for more information.

❏ ThethrottlestickMUSTbesetinthelowestpossibleposition,andthethrottletrimmustbeset

tothemiddleoralowerthanmiddleposition(themiddlepositionisindicatedbyalongerthan

usualbeep/tone),inorderforthe5-in-1unittoarm.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 91 92

Sem comentários

Blade mCX2 RTF Manual de Instruções Página 12