Blade BLH7900 Manual de Instruções

1EN®GB200 2-Axis Brushless Gimbal

10ENMounting the Camera132132CGO11. Slide the camera fully into the gimbal as shown.2. Install the 3mm screw through the mount and into the camera bod

11ENGimbal ModesTransmitter ProgrammingAngle Mode (Green LED) Velocity Mode (Blue LED)• The gimbal pitch angle corresponds directly to the position of

12ENLED CodesUsing the Gimbal1. Place the quadcopter on a fl at and stable surface. Ensure there are no obstructions in the path of the GB200.2. Switch

13ENTroubleshootingProblem Possible Cause SolutionThe gimbal vibrates after switching ONLoose camera Secure the camera in the mountGimbal does not res

14ENReplacement PartsExploded ViewOptional Parts# Part # Description1 BLH7904 Gimbal Arms: GB2002 BLH7905 Gimbal Motors: GB2003 BLH7906 Gimbal Mount:

15EN

©2014 Horizon Hobby, LLC.Blade and the Horizon Hobby logo are registered trademarks of Horizon Hobby, LLC.The Spektrum trademark is used with permissi

2ENWARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product co

3EN• Always keep a safe distance in all directions around your model to avoid collisions or injury. This model is controlled by a radio signal subjec

4ENA. GB200 2-Axis Camera Gimbalw/CGO1 compatible mounting plateB. Assembled isolation mountC. (4) Mounting ScrewsD. Knurled 3mm screwE. 3-wire harnes

5ENConnection PortsBCDAGEFLeft sideRight sideE. Software Update PortF. Yuneec™ Receiver PortG. Spektrum™ Remote Receiver PortA. 5V Power PortB. Unive

6ENInstalling the Isolation MountIf you are mounting the GB200 on a Blade® 350 QX (version 1), you will need to change the pre-installed top mounting

7ENRouting the Wiring• If you are installing the GB200 on a Blade 350 QX (version 1), use the included 2-wire harness (red and brown).• If you are ins

8ENChanging the Camera MountGoPro® usersThe GB200 comes with the CGO1 camera mountpre-installed. If you are using a GoPro® 3/3+ camera with your gimba

9ENInstalling the GimbalUsing a Remote Receiver for Pitch Axis ControlOn the original 350 QX quadcopter, the gimbal will automatically level without i