Blade Glimpse FPV RTF Manual de Instruções Página 1

RTFREADY-TO-FLY

10ENMLP4DSM Binding Procedure1. Disconnect the fl ight battery from the quadcopter.2. Center all trims on your transmitter.3. Power off the transmitter

11ENRTFTransmitter ControlFGHEADCBDual rate selectionH ABCDEFGHMode 1 Power LED/fl ight mode indicatorAileron (Left/Right) Throttle (Up/Down)Throttle T

12ENRTFFlight Mode and Rate Selection – RTFThe Glimpse™ RTF quadcopter comes with the Blade® MLP4DSM transmitter. This transmitter’s fl ight mode selec

13ENElevatorForwardElevator downElevator upBackwardLeft Side View Left Side ViewRudderRudder leftRudder rightNose Yaws RightNose Yaws LeftUnderstandin

14EN AileronAileron leftLeftAileron rightRightRear ViewRear ViewLED CodesEquipment LED Color LED Status OperationQuadcopterBlueRapid Blink Bind ModeSl

15EN Low Voltage Cuto (LVC)Once the battery reaches 3V under load, the ESC will continuously lower power supplied to the motor until complete shutdo

16EN SD card capacity usedPhoto buttonVideo record buttonApp ControlsRetrieving Your Photos and VideoThe Glimpse quadcopter comes with a micro SD card

17ENPost-Flight Inspection and Maintenance Checklist√Cleaning Make sure the battery is not connected before cleaning. Remove dust and debris with a so

18EN Problem Possible Cause SolutionReduced fl ight timeor is underpoweredFlight battery charge is low Completely recharge the fl ight batteryInadequate

19EN2465815673Exploded View

2ENWARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product co

20ENLimited WarrantyWhat this Warranty CoversHorizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the "Pr

21ENsions are at the sole discretion of Horizon. Proof of purchase is required for all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS

22ENWarranty and Service Contact InformationCountry ofPurchaseHorizon Hobby Contact Information AddressUnited States of AmericaHorizon Service Center(

23ENFCC InformationThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not c

92IT©2015 Horizon Hobby, LLC.Blade, E-fl ite, Glimpse, SAFE, the SAFE logo, DSM2, DSMX, Bind-N-Fly, the BNF logo, ModelMatchand the Horizon Hobby logo

3EN• Always keep a safe distance in all directions around your model to avoid collisions or injury. This model is controlled by a radio signal subject

4ENUSB Li-PoChargerEFLC1013SOLID RED LED–ChargingDC Input:5.0V 500mADC Output:4.2V 500mALED OFF–Charge CompleteBox Contents:• Blade® Glimpse™ Qu

5ENTable of ContentsFirst Flight Preparation ... 6Flying Checklist ...

6ENFirst Flight Preparation• Remove and inspect contents• Begin charging the fl ight battery• Install the fl ight battery in the quadcopter (once it ha

7ENInstalling the Transmitter Batteries (RTF)Install 4 AA batteries into the transmitter, noting polarity. Replace thetransmitter batteries when the p

8EN1. Lower the throttle and throttle trim to the lowest settings.2. Power on the transmitter.3. Install the battery by sliding it into the battery m

9ENTransmitter and Receiver BindingThe Glimpse quadcopter requires no radio-specifi c setup for basic fl ight. If you are using a computer transmitter,